ATD Tools ATD3699 Bedienungsanleitung PDF herunterladen (Seite 3)

Maintenance

Filter

Keyway

alignment

Pull straight out (do not

twist)

to remove

sensor

Unscrew tip to

replace filter

Push straight on (do not

twist) to install sensor

Batteries:

Install Batteries:

Remove screw located at rear end of unit and

pull down hinged battery door to open as shown. Always insert all

four batter

ies into the battery compartment in the same direction.

Note polarity mark on the inside of the battery door for proper

battery orientation.

Sensor:

Replace Filter

: Unscrew sensor tip as shown to replace filter.

Replace filter whenever it becomes visi

bly dirty or every 2 to 3

months depending on use.

Replace Sensor: Remove sensor by pulling out of socket.

Install

the new sensor by aligning the notch in sensor cover with the raised

keyway on sensor socket holder (see figure below).

Note: Do not force

sensor into socket. Misalignment can

damage the sensor pins.

Polarity Mark

ATD3699 Control Panel

Operating Instructions

1. TURN ON:

Press the ON/OFF button once to turn on and again

to turn off.

2. WARM UP

: The detector automatically starts heating the sensor.

During the heating cycle, the digital leak size indicator will flash 0

and the detector will sound a slow “beep”. Warm up is usually

less than 20 seconds.

3. READY

: The detector is ready to begin searching for leaks when

the flashing 0 stops and the green sensitivity LED turns on. T

audio “beep” increases in frequency and probe LED begins to

blink steadily.

Digital Leak Size

Indicator

Low Battery

Indicator

Sensitivity Level

Indicator

Audio Mute &

Sensitivity Level

Power

On/Off

1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare

ATD Tools ATD3699 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein ATD Tools ATD3699